Chart: Fixing both axes ranges ignores that set for the right

Stimulsoft Ultimate discussion
Post Reply
Chris42
Posts: 27
Joined: Fri Aug 18, 2017 5:50 pm

Chart: Fixing both axes ranges ignores that set for the right

Post by Chris42 » Tue Jul 09, 2019 2:25 pm

Hi,

I have a simple chart with 2 lines series, one against the left Y Axis, the other to the Right.

With at least one Range set to Auto it behaves OK - both series are fully displayed.

If I have both fixed then the series using the right axis ignores the fixed range - seems to auto scale but incorrectly with some values off the chart area

Any suggestions to the cause? Example project attached.

Thanks,
Chris

Reports Designer v2019.3.2
Attachments
Stimulsoft Right Axis issue - Good.png
Stimulsoft Right Axis issue - Good.png (45.11 KiB) Viewed 236 times
Stimulsoft Ignored RHS Fixed Range2.mrt
(15.76 KiB) Downloaded 24 times
Stimulsoft Right Axis issue - Good.png
Stimulsoft Right Axis issue - Good.png (45.11 KiB) Viewed 237 times
Stimulsoft Ignored RHS Fixed Range2.mrt
(15.76 KiB) Downloaded 9 times
Stimulsoft Right Axis issue - Good.png
Stimulsoft Right Axis issue - Good.png (45.11 KiB) Viewed 238 times
Stimulsoft Right Axis issue - Bad.png
Stimulsoft Right Axis issue - Bad.png (46.07 KiB) Viewed 238 times
Last edited by Chris42 on Tue Jul 09, 2019 2:27 pm, edited 1 time in total.
Chris42
Posts: 27
Joined: Fri Aug 18, 2017 5:50 pm

Re: Chart: Fixing both axes ranges ignores that set for the right

Post by Chris42 » Tue Jul 09, 2019 2:27 pm

Seemed to have lost the project; attached here.
Attachments
Stimulsoft Ignored RHS Fixed Range2.mrt
(15.76 KiB) Downloaded 9 times
Lech Kulikowski
Posts: 1871
Joined: Tue Mar 20, 2018 5:34 am

Re: Chart: Fixing both axes ranges ignores that set for the right

Post by Lech Kulikowski » Sat Jul 13, 2019 9:25 pm

Hello,

We need some additional time to investigate the issue.

Thank you.
Chris42
Posts: 27
Joined: Fri Aug 18, 2017 5:50 pm

Re: Chart: Fixing both axes ranges ignores that set for the right

Post by Chris42 » Mon Jul 15, 2019 2:14 pm

Much appreciated
Lech Kulikowski
Posts: 1871
Joined: Tue Mar 20, 2018 5:34 am

Re: Chart: Fixing both axes ranges ignores that set for the right

Post by Lech Kulikowski » Tue Jul 16, 2019 7:13 am

Hello,

Unfortunately, it is not possible to set Range for both axes in one Chart. Sorry.

Thank you.
Post Reply