Stimulsoft Business Intelligence System | Forum

Posted: **Tue Jul 09, 2019 2:25 pm**

Hi,

I have a simple chart with 2 lines series, one against the left Y Axis, the other to the Right.

With at least one Range set to Auto it behaves OK - both series are fully displayed.

If I have both fixed then the series using the right axis ignores the fixed range - seems to auto scale but incorrectly with some values off the chart area

Any suggestions to the cause? Example project attached.

Thanks,
Chris

Reports Designer v2019.3.2

Posted: **Tue Jul 09, 2019 2:27 pm**

Seemed to have lost the project; attached here.

Posted: **Sat Jul 13, 2019 9:25 pm**

Hello,

We need some additional time to investigate the issue.

Thank you.

Posted: **Mon Jul 15, 2019 2:14 pm**

Much appreciated

Posted: **Tue Jul 16, 2019 7:13 am**

Hello,

Unfortunately, it is not possible to set Range for both axes in one Chart. Sorry.

Thank you.

Stimulsoft Business Intelligence System | Forum

Chart: Fixing both axes ranges ignores that set for the right

Chart: Fixing both axes ranges ignores that set for the right

Re: Chart: Fixing both axes ranges ignores that set for the right

Re: Chart: Fixing both axes ranges ignores that set for the right

Re: Chart: Fixing both axes ranges ignores that set for the right

Re: Chart: Fixing both axes ranges ignores that set for the right