Getting #%# instead of Count()

[olegtr]

Hello.

We have a databand Data1.
Below it we have some other databands and at the end we have an unbound databand where we present aggregates.
We have the following expression there {Count(Data1)}.
When Data1 databand has rows the expression is properly calculated.
When Data1 has no rows we get this: #%#{Count(Data1)}.

How can we make the expression to evaluate to 0 in this case?

Thank you.

[HighAley]

Hello.

Sorry, we can't reproduce the issue on our current build.
Which version do you use?

Thank you.

[olegtr]

StimulsoftReports.Net 2014.2

[Ivan]

Hello,

If we diagnose the issue in the correct way, the problem is already fixed in the latest version.
Please check the latest prerelease build or last release and let us know about the result.
If the issue is still present, please send to us a sample report template with data, which reproduce the issue, for analysis.

Thank you.

[olegtr]

Thank you, Ivan, but we currently cannot upgrade to newer version of Stimulsoft Reports.Net.

We have sources of the StimulsoftReports.Net 2014.2.
Could you provide a source code fix for the problem which we will integrate manually and compile?

Best regards,
Oleg

[Andrew]

Dear Oleg,

In order to check the ability to add the fix into such old version, please send us a request to support@stimulsoft.com.
Our team will investigate this. Please refer to this forum thread in the email.

Thank you.