Hi,
I have a simple chart with 2 lines series, one against the left Y Axis, the other to the Right.
With at least one Range set to Auto it behaves OK - both series are fully displayed.
If I have both fixed then the series using the right axis ignores the fixed range - seems to auto scale but incorrectly with some values off the chart area
Any suggestions to the cause? Example project attached.
Thanks,
Chris
Reports Designer v2019.3.2
Chart: Fixing both axes ranges ignores that set for the right
Chart: Fixing both axes ranges ignores that set for the right
- Attachments
-
- Stimulsoft Right Axis issue - Good.png (45.11 KiB) Viewed 2132 times
-
- Stimulsoft Ignored RHS Fixed Range2.mrt
- (15.76 KiB) Downloaded 215 times
-
- Stimulsoft Right Axis issue - Good.png (45.11 KiB) Viewed 2133 times
-
- Stimulsoft Ignored RHS Fixed Range2.mrt
- (15.76 KiB) Downloaded 173 times
-
- Stimulsoft Right Axis issue - Good.png (45.11 KiB) Viewed 2134 times
-
- Stimulsoft Right Axis issue - Bad.png (46.07 KiB) Viewed 2134 times
Last edited by Chris42 on Tue Jul 09, 2019 2:27 pm, edited 1 time in total.
Re: Chart: Fixing both axes ranges ignores that set for the right
Seemed to have lost the project; attached here.
- Attachments
-
- Stimulsoft Ignored RHS Fixed Range2.mrt
- (15.76 KiB) Downloaded 199 times
-
- Posts: 6259
- Joined: Tue Mar 20, 2018 5:34 am
Re: Chart: Fixing both axes ranges ignores that set for the right
Hello,
We need some additional time to investigate the issue.
Thank you.
We need some additional time to investigate the issue.
Thank you.
Re: Chart: Fixing both axes ranges ignores that set for the right
Much appreciated
-
- Posts: 6259
- Joined: Tue Mar 20, 2018 5:34 am
Re: Chart: Fixing both axes ranges ignores that set for the right
Hello,
Unfortunately, it is not possible to set Range for both axes in one Chart. Sorry.
Thank you.
Unfortunately, it is not possible to set Range for both axes in one Chart. Sorry.
Thank you.