Page 2 of 2
Re: Change control height in before print
Posted: Thu Dec 20, 2012 9:56 am
by nemanja.avramovic
Thank you, you are kind.
Re: Change control height in before print
Posted: Thu Dec 20, 2012 2:14 pm
by HighAley
Hello.
We are always glad to help you.
Let us know if you need any additional help.
Thank you.
Re: Change control height in before print
Posted: Thu Dec 20, 2012 3:12 pm
by nemanja.avramovic
Hi,
since you mentioned additional help, I am not sure if my requests were clear enough.
So I prepared testReport with data backup (mssql db) for you. This is the concrete scenario where I need your help.
This may help you in your analysis for problem reproduction and making solution.
Best regards!
Re: Change control height in before print
Posted: Fri Dec 21, 2012 10:34 am
by HighAley
Hello.
We avoid the use of sub-report.
Please, look at the attached report template.
Thank you.
Re: Change control height in before print
Posted: Fri Dec 21, 2012 2:24 pm
by nemanja.avramovic
Thank you very much!
This is a great solution and simplification in one.
I was convinced that Subreport was necessary for relation binding on CrossTab.
Perhaps, Subreports are for relating only among DataBands.
I am satisfied, this topic has the good ending.
The only thing that remained mystery for me are report events on controls: Before print, After print, Get value, Get tag, and so on...
I was looking in Stimulsoft_Reports_Manual.En.pdf and had not found anything about it.
Can you, please, refer me where I can learn more about them, when they occur, how many times, and what arguments are available?
Thanks again, and best regards!
Re: Change control height in before print
Posted: Sat Dec 22, 2012 1:43 pm
by HighAley
Hello.
nemanja.avramovic wrote:Thank you very much!
This is a great solution and simplification in one.
I was convinced that Subreport was necessary for relation binding on CrossTab.
Perhaps, Subreports are for relating only among DataBands.
There are several bands could be on the one page so it's better to avoid using sub-reports.
nemanja.avramovic wrote:I am satisfied, this topic has the good ending.
The only thing that remained mystery for me are report events on controls: Before print, After print, Get value, Get tag, and so on...
I was looking in Stimulsoft_Reports_Manual.En.pdf and had not found anything about it.
Can you, please, refer me where I can learn more about them, when they occur, how many times, and what arguments are available?
We are working on our documentation permanently. We will add a chapter about events in our next release.
Thank you.
Re: Change control height in before print
Posted: Mon Dec 24, 2012 8:45 am
by nemanja.avramovic
That's great!
Thanks for answers.
Re: Change control height in before print
Posted: Tue Dec 25, 2012 7:59 am
by HighAley
Hello.
We are always glad to help you.
Thank you.