Creating reports and dashboards | Stimulsoft community forum

I try databand Columns but still nothing. I am try to drive my data in both direction vertical and cross is it possible with mrt at the same time? if yes then will you please provide me an example mrt file with xml data file.

Thanks

Hello,

Thank you for writing.

Please read the following topic http://www.stimulsoft.com/en/documentat ... a_band.htm
This should help you.

Also in our DEMO application, please see the report templates from the section Reports with Columns

Please let us know if you need more clarification.
Thank you.

its fine but if you go through the sample report attached with this query maintain relations based on id but with columns how can i use relation for that?

thanks

Hello,

Your report with difficult structure with many nested bands, please try to simplify your report.

Thank you.

I tried but i dont get any alternate to flow my data in both of the direction on same time with relation between datasource.
Is there any can break property for cross databand. Please suggest your valuable advise for that.

Thanks

Hello.

roomy wrote:I tried but i dont get any alternate to flow my data in both of the direction on same time with relation between datasource.
Is there any can break property for cross databand. Please suggest your valuable advise for that.

Unfortunately, there is no Can Break property of the Cross Data.

Thank you.

please suggest me what changes I have to made in my mrt file to solve that issue. Please use attached report for that. I hope you may help me to got the right report file for my solution after changes.

Hello.

Our support have many difficult questions from our customers. We solve problems if it depends on our bugs. But we can't create reports for ALL our costumer, we just help to understand what the problem in.

Please, describe what problems do you have with creating such report.
You should use our sample and correct it for your needs.

Thank you.

Yes I can understant that you just help us to resolve critical issues. And the issue is when I create a report with multiple section and use databand crossband and a table in crossband and have two set of that controls both section create a whitespace between them in report. I already attach sample report and xml and image file for that. I again attach that hope u can tell me where I am wrong in that report.

regards
Roomy

Hello,

Yes, our product has the opportunity to put components into each other. But it is necessary to use this in a reasonable way. Besides that you are using rather complex constructions of items (Cross-Data and Table). In addition you embed them into each other.
In this case, you will probably need to completely redesign your report. Perhaps this will need to slightly modify data output, etc. It is difficult to advise something we do not know thoroughly the logic of your report and your data.