Stimulsoft Business Intelligence System | Forum

Hi,
i have following print requirements

1.0.25 inch bleed

2.Crop marks, offset 30 pt (.4167 inch)

3.Final print size after cuts is 8 3/8" x 10 7/8" built as 8 ½” x 11”

Please tell, how to set this requirements in template?

Thanks in advance,
Jayakumar

Hi Jayakumar,

Do you print from Dot matrix mode?

Thank you.

Hi Edward,

No.We are using Plateprinting CTP printers.
Regards,
Jayakumar

Have you tried to double click the page in the designer and to set the required margins and page height and width?

Which problems have you faced?

Thank you.

Hi Edward,

There is no problem in margin settings and page width and height.i don't know how to set the bleed(previous post requirements) using those margins and page width and height.

Please help me to solve the requirements.

Thanks in advance,
Jayakumar

Hi Edward,
Have you found the solution ? if you found then please reply me.

Regards,
Jayakumar

Hello,

Can you explain what is "previous post requirements" ?

Thank you.

Hi,
i have following print requirements

1.0.25 inch bleed

2.Crop marks, offset 30 pt (.4167 inch)

3.Final print size after cuts is 8 3/8" x 10 7/8" built as 8 ½” x 11”

Please tell, how to set this requirements in template?

Thanks in advance,
Jayakumar

---------------------------------
Hi Edward,

No.We are using Plateprinting CTP printers.
Regards,
Jayakumar
-----------------------------------

Hi Edward,

There is no problem in margin settings and page width and height.i don't know how to set the bleed(previous post requirements) using those margins and page width and height.

Please help me to solve the requirements.

Thanks in advance,
Jayakumar

Hi Jayakumar,

Our report generator can set the magins of printing, type of paper, paper size.

All other settings you may setup manually using components of the report generator (bands etc)

Thank you.