Page 1 of 1
Multiselection on report wider than designer window
Posted: Thu Sep 03, 2009 1:33 am
by m.n
Hello,
Components are placed from the left report's edge to the right one and some of them are invisible at the moment, because of current zoom level.
How can I select all those components? Can I pan the report while selecting?
--
Mariusz
Multiselection on report wider than designer window
Posted: Fri Sep 04, 2009 2:27 pm
by Jan
Hello Mariusz,
You can use Edit-Select All (Ctrl-A) menu item from report designer.
Thank you.
Multiselection on report wider than designer window
Posted: Mon Sep 07, 2009 2:19 am
by m.n
You can use Edit-Select All (Ctrl-A) menu item from report designer.
Yes, I could if I'd like to select
all components.
But my question is about panning while in multi-selection mode. Or an alternative method to
quick multiselect of components currently outside the window.
I have components placed, for example, in two horizontal lines. How to select only those which are in the first one? Now I must zoom out to see all components then use multiselection feature, then zoom in to original level. Or Ctrl-click on every one (and pan between clicks, of course). Quite non-comfortable, isn't it?
--
Mariusz
Multiselection on report wider than designer window
Posted: Tue Sep 08, 2009 5:32 am
by Jan
Hello Mariusz,
We can think about autoscrolling for design surface. What you think about this?
Thank you.
Multiselection on report wider than designer window
Posted: Thu Sep 10, 2009 5:23 am
by m.n
Autoscrolling is quite good idea for me.
Manual panning seems to be worse.
Thank you.
--
Mariusz
Multiselection on report wider than designer window
Posted: Fri Sep 11, 2009 3:22 pm
by Jan
Hello Mariusz,
Ok. Accepted.
Thank you.