Page 1 of 1
StiWebViewer in MultiView Error
Posted: Mon Nov 27, 2006 7:22 am
by fabiomatos
At Design mode in VS2005, when I place a StiWebViewer in a Multiview component, If I go to source mode and go back to design mode then occurs a error: Error rendering control - MultiView1. An unhandled exception has ocurred. The control collection cannot be modified during DataBind, Init, Load, PreRender or Unload phases.
StiWebViewer in MultiView Error
Posted: Tue Nov 28, 2006 6:20 am
by Edward
We confirm a problem with a Multiview component.
When a solution of the problem will be ready we will inform you by post in this topic.
Thank you.
StiWebViewer in MultiView Error
Posted: Thu Nov 30, 2006 10:17 am
by fabiomatos
The problem has ocurred with Panel too.
StiWebViewer in MultiView Error
Posted: Fri Dec 01, 2006 2:13 am
by Edward
Fixed. This ability will be available in the build from December, 1.
Thank you.