Creating reports and dashboards | Stimulsoft community forum

I have a report with three data sources, with column headers for the second and third data bands. The problem is that on the last data band, the column header was not printing if the data wrapped to page two. So, I set it to print on all pages, which makes it print on page two if the data wraps to page two; however, if the last data section begins printing on page two, it's column header prints twice- once with no data, then it prints the data it should. What setting can fix this? I have attached the .mrt file. There is also a pdf with an example of the header issue.

Hello,

ColumnHeaders are used only with columns.
If number of columns is 0, then, instead of ColumnHeaders, it is necessary to use ony Headers.

Thank you.