Creating reports and dashboards | Stimulsoft community forum

Hello,

another issue concerns the viewer: When scrolling down on a multi-page report, the focus stays on the first page until you select another page by clicking on it. This is especially annoying if the viewer is refreshed during the comparison of two reports for example. Then the viewer shows the selected page from its upper edge again (instead of where it was last).
I was looking for a possibility to always select the currently visible page or to disable this auto scrolling at all.

Best regards & thanks in advance

Claus

Windows XP SP3, Stimulsoft WPF SWPF_2010.08.10 (.NET Framework 3.5 & 4.0)

Hello,

We do not exactly understand what is the problem with scrolling and focusing. On the current moment the focusing in the WPF editor works this way: focus remains on the page that is selected and it is the correct behavior.

Thank you.

Hello Aleksey,

thanks for your reply, but is there any way to change that behavior? Like always selecting the currently visible page?
An alternative way would be to turn the auto-scrolling, that takes you to the currently selected page, off.

Best regards,

Claus

Hello,

We have added your request to our to-do list.
Patch will be available in next prerelease build.

Thank you.

Hello,

The problem is fixed. The patch is available in prerelease build of on 23.08.2010.

Thank you.