Creating reports and dashboards | Stimulsoft community forum

Occasionally, when I double click on a databand (then it shows a popup), and then I simply hit OK, it clears the data source, sort, relation, etc. This only happens sometimes. I think the bug is related to use master components and/or relations.
I attached a sample that demonstrates the problem ... just open the report ... double click on DataBand3, then just hit OK. You will notice that Data source changes to Not Assigned (and Relations is cleared).

Any ideas why this occurs sometimes, and can this be fixed?

thx

Hello.

There is a Connection and a Data Source with the same name.
Please, rename the GTY_Data connection.

Thank you.

It seems that the report builder creates this connection when I create a new Datasource from other Datasource, which is always the same name as the datasource I point to. This normally does not cause problems, but in this example it does seem to cause the problem ... I cannot rename the GTY_Data connection as it was created automatically.

Thoughts?

Hello.

jay@bplogix.com wrote:It seems that the report builder creates this connection when I create a new Datasource from other Datasource, which is always the same name as the datasource I point to. This normally does not cause problems, but in this example it does seem to cause the problem ... I cannot rename the GTY_Data connection as it was created automatically.

In your report the problem exactly in the same name of the Connection and the Data Source. If you change it in the Designer you will see it.
It's possible to set the name of connection, but we need to know how do you add the connection.

Thank you.