Page 1 of 1
Blank Report at run time
Posted: Wed Jun 04, 2014 7:35 pm
by drp1994
I can successfully run and view the report in the stimulsoft designer, but when I run it over the web it is blank with no errors.
I can see the report manager window, just none of the report data.
Re: Blank Report at run time
Posted: Thu Jun 05, 2014 9:18 am
by Alex K.
Hello,
Can you please send us a sample project which reproduce the issue for analysis.
Thank you.
Re: Blank Report at run time
Posted: Thu Jun 05, 2014 1:46 pm
by drp1994
I found that it was when I had one of the parameters set to be Bit in the stored procedure.
when I pulled that into the Designer it displayed results just fine.
But when I was pulling it into the Viewer, it would results in blank Screen.
I changed the parameter from bit to char and it seems to be working now.
But if you have any suggestions as to how to get the Bit Parameters to work in the viewer, that would be greatly appreciated.
Re: Blank Report at run time
Posted: Fri Jun 06, 2014 6:20 am
by Alex K.
Hello,
It is difficult to say something about the issue without any sample which reproduce the issue.
Thank you.