Creating reports and dashboards | Stimulsoft community forum

Hello,

2 questions about crosstabs:
- when adding a row, the total is automatically added at the bottom. Is there a way to disable this automatic addition? I don't need the total cell, so I have to unselect it for each row, which is quite annoying.

- when there is no data to fill the columns, Stimulsoft create a small blank column, instead of showng nothing. See screenshot below. Can I do something so that this blanck column is not shown? Thank you!

Hello.

Jennypi wrote:- when adding a row, the total is automatically added at the bottom. Is there a way to disable this automatic addition? I don't need the total cell, so I have to unselect it for each row, which is quite annoying.

Unfortunately, it's impossible to disable totals for columns automatically.

Jennypi wrote:- when there is no data to fill the columns, Stimulsoft create a small blank column, instead of showng nothing. See screenshot below. Can I do something so that this blanck column is not shown?

If there is no data at all. Then it's will be empty column. If you don't need the cross-tab at all, try to disable it by Conditions.

Thank you.

Thanks for your reply.
Well, I would be a nice option to disable the Totals

For my second question, I am attaching my report. Could you please explain how I can do? The problem is that if I disable my cross tab, my report is empty, as the cross tab contains all the columns...
Can you please check attached report?

Thank you.

Hello,

Can you please send us a test data for your report?

Thank you.