Page 1 of 1
StiMobileViewer, user variables not showed in a top panel
Posted: Tue Aug 25, 2015 11:05 pm
by FrenkR
using StiMobileViewer/StiMobileDesigner, I have set
Code: Select all
ShowPanelParameters="true" ShowParametersButton="true"
and on report I have defined variable with "Request from user" and "Allow user values" checkbox.
Parameters panel, as from HTML or flash is not displayed. I also saved report from demo version "ParametersInvoice.mrt" and displayed him inside StiMobileViewer. Again, parameters panel on top is not displayed nor in a preview tab nor in a viewer.
It looks like a problem is in a viewer. Is this intended behavior?
Rgds,
Frenk
Re: StiMobileViewer, user variables not showed in a top pane
Posted: Wed Aug 26, 2015 9:24 am
by HighAley
Hello, Frenk.
Could you specify what version of our assemblies you use?
Maybe the Request From User panel had not been implemented?
Could you send us a report template?
Thank you.
Re: StiMobileViewer, user variables not showed in a top pane
Posted: Wed Aug 26, 2015 12:16 pm
by FrenkR
version is 2015.1.12.
what is " Request From User panel"? Maybe this is a problem?
I attached my template.
Re: StiMobileViewer, user variables not showed in a top pane
Posted: Thu Aug 27, 2015 12:00 pm
by HighAley
Hello, Frenk.
The Request From User panel is the panel which is shown to enter variable values if the Request from user parameter is set.
It is not shown in Preview of Mobile Designer. Please, try to open the report in Mobile Viewer. There should be all right.
Thank you.
Re: StiMobileViewer, user variables not showed in a top pane
Posted: Fri Aug 28, 2015 3:05 am
by FrenkR
I have showpanelbuttons and showpanelparameters enabled in mobile viewer. Also I updated to latest version (2015.1.18). Parameters are still not displayed.
Re: StiMobileViewer, user variables not showed in a top pane
Posted: Fri Aug 28, 2015 6:27 am
by HighAley
Hello, Frenk.
Sorry, but it's very hard to say what is wrong with your project.
Could you send us a screen-shot of the Viewer?
Also we need to see your project.
Thank you.
Re: StiMobileViewer, user variables not showed in a top pane
Posted: Fri Aug 28, 2015 8:58 am
by FrenkR
Ok, will try to ask other way.
Can I define user variables using StiMobileDesigner?
Is there any special designer for this "request form user" panel? If yes, which designers are supported with this functionality?
Is the only setting checkbox in varables "request form user" or is there any other "general" setting to enable this request form panel?
is there any additional component or runtime assmembly that must be added to (StiMobileViewer component on aspx page) a project to show parameters?
can you provide a simple demo with 1 parameter and add it to a HTML5 samples folder?
Best regards,
Frenk
Re: StiMobileViewer, user variables not showed in a top pane
Posted: Fri Aug 28, 2015 11:50 am
by Alex K.
Hello,
Please check the last sample reports on our online Demo:
http://mobile.stimulsoft.com/
Thank you.