Creating reports and dashboards | Stimulsoft community forum

I have a report spec that is measured in millimeters.

When I set the milimeters at .5 or (1) during in the designer the grid works with the .5 mm setting.
And the report produces the correct results when rendered in a viewer.

The setting does not save and I have to set it back every design session.

It seems to revert back to the default mm setting.

Hello.

We have reproduced the issue.
We need to make an improvement.
We will let you know when the Grip parameters will be saving.

Thank you.

Hello.

We have made an improvement.
The fix will be available in our next build on Friday.

Thank you.