Creating reports and dashboards | Stimulsoft community forum

I found two problems with a report "chopping" information.

The first is that the label for a column can be chopped if the column is tall. Look at the screenshot and the first column ... notice the label is cut off.

The second problem is that if you change the page margins to 0; 0; 0; 0, and stretch a chart to the entire width, the chart seems to clip a pixel from the yellow band around the chart. Look at the screen shot and notice the left and right circled areas ... see how a single pixel is missing around the chart. Shouldn't the chart be "inside" the yellow band rather than overwriting a piece of it?

Thanks,
Jay

Hello,

The first is that the label for a column can be chopped if the column is tall. Look at the screenshot and the first column ... notice the label is cut off.

We could not reproduce the problem. Please tell us which version you use?

The second problem is that if you change the page margins to 0; 0; 0; 0, and stretch a chart to the entire width, the chart seems to clip a pixel from the yellow band around the chart. Look at the screen shot and notice the left and right circled areas ... see how a single pixel is missing around the chart. Shouldn't the chart be "inside" the yellow band rather than overwriting a piece of it?

This is a correct behavior. The idea of it is that all components on the page margin not to be overlayed with current page indicator.


Thank you.

I just attached a chart with built-in data that reproduces the chopping of the first chart label in the first bar. I am using SW_2011.07.13.

Hello,

We have reproduced the problem, we will try to solve it during the week.

Thank you.

About the clipping of an entire verticle line (about a pixel in width) from the yellow band around the chart ... you responded:
"This is a correct behavior. The idea of it is that all components on the page margin not to be overlayed with current page indicator. "

I am not sure what that means. Are you saying it is by design that the yellow outline band is clipped even if the report does not extend of of its boundaries?

Hello,

To resolve this behavior, please set the Brush property of the Chart component to Empty.

Thank you.