Creating reports and dashboards | Stimulsoft community forum

Hi,

In the designer, I want to use thee differents page footer bands.
The first one must print on the first page only, the second on all page except the first and the last, and the third one must only print on the last page.
But I'm also using the "segment per width" property egal to the value 2 and The contents of the page footer bands must only print on the left side.
In this case, the "print on" property does not work correctly. I tried to use conditions, but expressions like "PageNumber==TotalPageCount-1" or "PageNumber==TotalPageCount" don't run.

Is there another solution ?


Regards,
A. Lepage

Hello.

alepage wrote:In the designer, I want to use thee differents page footer bands.
The first one must print on the first page only, the second on all page except the first and the last, and the third one must only print on the last page.
But I'm also using the "segment per width" property egal to the value 2 and The contents of the page footer bands must only print on the left side.
In this case, the "print on" property does not work correctly. I tried to use conditions, but expressions like "PageNumber==TotalPageCount-1" or "PageNumber==TotalPageCount" don't run.

Is there another solution ?

For better answer, please, send us a sample report template with data to reproduce your issue.

Thank you.

OK, a email has been sent to support@stimulsoft.com.

Thanks

Ok!

Thank you.