Page 1 of 1
Set variable list default to unchecked
Posted: Tue May 24, 2016 1:40 pm
by Jacunio
Is possible to set list variable default to unchecked? I am using parameter variable set as list with about 800 values.
At default all is set as checked, when using uncheck all at the end of the list, it takes very long to uncheck in StiWebViewer.
It always throw running script error, is it possible to set list to unchecked at start?
I understand that it is new option, but I think it needs some improvement also.
Thank you
Jacek
Re: Set variable list default to unchecked
Posted: Tue May 24, 2016 2:21 pm
by HighAley
Hello, Jacek.
Could you specify which version of our product you use?
We have completely new StiWebViewer now.
Thank you.
Re: Set variable list default to unchecked
Posted: Tue May 24, 2016 2:29 pm
by Jacunio
I am using 2016.1.12.0, newest one.
Re: Set variable list default to unchecked
Posted: Wed May 25, 2016 6:59 am
by Alex K.
Hello,
We have added this task to our to-do list. Try to add this option in the near future.
Thank you.
Re: Set variable list default to unchecked
Posted: Fri May 27, 2016 8:18 am
by lanfro
Hi!
We also have this requirement for one of the reports. While it is not suppported in editor GUI in the current version, is it still possible to achieve this functionality by writing code in the code behind file for the report when it starts up? If yes could you provide a code sample that shows how to do it please? We are using the 2014.1.1900 version of Stimulsoft Ultimate.
Regards
Frode
Re: Set variable list default to unchecked
Posted: Fri May 27, 2016 1:26 pm
by Alex K.
Hello,
Unfortunately, it is not possible by code.
Thank you.