Creating reports and dashboards | Stimulsoft community forum

Our Datasource can be quite large and at the moment when the contents of page 1 are too long, it flows onto page 2.
It then causes a break and the the contents of designer page 2 starts on page 3.

Is it possible to get designer page 2 to continue on where the end of designer page 1 finished i.e. page 2 ?

It should render to A4 but just continue on after each other.

regards

Richard

Please ignore. Found solution here.

http://forum.stimulsoft.com/Default.aspx?g=posts&t=4267.

It works great.

regards.

Hello,

Ok! Thank you.