Creating reports and dashboards | Stimulsoft community forum

I can't seem to figure out how to make ColumnHeaderBand split like the DataBand does when you set the column count.

In the Stimulsoft_Report.Fx_Manual.En.pdf manual on page 483 is shows how to do this, but in the manual it had a picture of the ColumnHeaderBand already split into 3 columns like the DataBand is.
When I try and do my ColumnHeaderBand is only 1 column even though my DataBand right underneath it is set to 3 columns and shows the column breaks.

Any ideas?

Hello,

We made some improvements in that direction.
Please check the next prerelease build when it will be available and let us know about the result.

Thank you.

I have AIR Designer
Version 2012.1.1204
Flash 11.1.102

Does not seem to be doing anything different.
There is no column parameter in ColumnHeaderBand like there is in a normal DataBand nor does the ColumnHeaderBand auto split if placed above a already split DataBand.

Hello.

ivanleblanc wrote:I have AIR Designer
Version 2012.1.1204
Flash 11.1.102

Does not seem to be doing anything different.
There is no column parameter in ColumnHeaderBand like there is in a normal DataBand nor does the ColumnHeaderBand auto split if placed above a already split DataBand.

This feature doesn't available now. It will be in our next prerelease build 2012.1.1205 this week.

Thank you.

Thank you for the update.
This feature has been tested and is working for me now.
in build 2012.1.1205

Hello,

Ok.
Let us know if you need any additional help.

Thank you.