Creating reports and dashboards | Stimulsoft community forum

Hi!

I have a small problem with the Silverlight Report Designer.
My report has 2 variables (From/To) to show only a range of data.

Therefore if i have a look at the preview tab it shows me 2 DateTimePicker for setting this 2 variables.
If i press now "Preview" it generates the report (WCF).

But if i change now the report (relocating a image for example), switch to preview again, pressing "preview" the changes are ignored and the report looks the same as before.
Anybody with the same problem ?

Hello,

We made some improvements in that direction about a week. Please check the latest prerelease build.

Thank you.

I´m using version 2012.1.1211.0, is there any newer one ?

Hello,

The problem is fixed. The patch is available in prerelease build of on 16 February 2012.

An updated WCF example is available too.
http://www.stimulsoft.com/ShowNews.aspx?id=2360

Thank you.