Creating reports and dashboards | Stimulsoft community forum

run Stimulsoft Report Demo

1. select node ->Dialog - Selecting Rows
2. after preview click on design
3. select report from property
4. Change Calculation mode - 'Compilation' to 'Interpretation' on report
5. Preview
6. Remove some selection or select only two -three rows
7. boom wrong result :surr:

result : may be 'Interpretation' not working properly if you have some condition in databand or other band

Hello,

In this sample the additional code is used, but in the 'Interpretation' mode additionals code it is not supported.
In this mode you cannot use additional code.

Thank you.

thanks for reply

In this mode you cannot use additional code.

means if we use 'Interpretation' calclulation mode so filter condition or any other conditions on band/text or any report component will not work !

or any sample report using 'Interpretation' with condition are available ?

Hello,

Conditions and filters supported in 'Interpretation' mode.
But if in it do you use difficult expression then most probably it will not work.

Thank you.

Hello, I ‘m use Stimulsoft report ver. 2018.1.3.
To now, we used calculation - "compilation mode". But we had issue with "Out Of Memory" exception on devices. I found discussion about "Interpretation" mode and recommendation to use it.
We changed calculation to "Interpretation" mode, but this change caused another big issue. Condition feature not working after that.
There is some limitation for "Interpretation" mode”?? Conditions and filter are ignored right now!

Hello,

Were made a lot of fixes and optimization from the 2018 version. Please check the last build.

If the issue is still present, please send us a sample report with test data that reproduces the issue for analysis.

Thank you.