Page 1 of 1
Unable to get the Exporting/Exported report events to fire
Posted: Tue Aug 08, 2017 3:07 pm
by leetyler
Using 2012.3.1500.0 Stimulsoft Reports.Net, am unable to get the Exporting or Exported report events to fire any code.
Re: Unable to get the Exporting/Exported report events to fi
Posted: Wed Aug 09, 2017 1:47 pm
by Alex K.
Hello,
Please clarify which product are you use, on your screenshot, it is the Web product and flash preview in which events are not supported.
Thank you.
Re: Unable to get the Exporting/Exported report events to fi
Posted: Wed Aug 09, 2017 5:06 pm
by leetyler
Attached, the Properties window to show the version of Designer.exe.
Also, I do get access to the other events, i.e. the BeginRender - see attached. (But the MessageBox's do not show up when Exporting to CSV (or any other format, for that matter.))
Thanks for your reply.
Re: Unable to get the Exporting/Exported report events to fi
Posted: Wed Aug 09, 2017 8:18 pm
by HighAley
Hello.
The events are working in the .Ner report engine only.
When you open the Web Preview, the Flex engine is run.
The events are not working there.
You should use the Preview tab, but we don't see this tab on your screenshot.
How you you run the Designer?
Thank you.
Re: Unable to get the Exporting/Exported report events to fi
Posted: Wed Aug 09, 2017 8:28 pm
by leetyler
Attached, a full screen shot, after a refresh. Note that the "Begin Render" code runs when I do a "Refresh" on "Web Preview", but when I "Save" to "CSV File", the two events "Exporting and "Exported" do not execute.
Re: Unable to get the Exporting/Exported report events to fi
Posted: Wed Aug 09, 2017 8:57 pm
by Alex K.
Hello,
Please clarify which designer do you run? The Reports.NET contains absolutely others Tabs in the designer.
Thank you.