Cross band data not correct on second page
Posted: Tue Nov 13, 2018 1:41 pm
Hello,
I have a question about cross bands. I created a report where I have one panel with multiple data bands.
Inside each data band, I have a cross band which is filtered on the datasource.
Each cross band has same datasource, but another filter. When data is too big to show on one page, there is always a new page created.
Can anyone tell me what i'm doing wrong ?
Second page should contain same amount of lines as first page. They are somehow not grouped/seen as one page.
I have a question about cross bands. I created a report where I have one panel with multiple data bands.
Inside each data band, I have a cross band which is filtered on the datasource.
Each cross band has same datasource, but another filter. When data is too big to show on one page, there is always a new page created.
Can anyone tell me what i'm doing wrong ?
Second page should contain same amount of lines as first page. They are somehow not grouped/seen as one page.
- stimulsoft1.PNG (160.81 KiB) Viewed 2106 times