Creating reports and dashboards | Stimulsoft community forum

Hi there!
I am new to this forum and quite new to Stimulsoft; I hope do not annoy you guys, experts on Stimulsoft.

I created a new report on the stimulsoft tool embeded on a access control system we use here.

It works fine, but I get a timeout message on reports with lots of photos: about 200 photos(not huge pics).
The timeout message is attached to this message, as well as the report itself.

If I remove the photos from the report it works fine. I've already set the CommandTimeout to 900 seconds, but I get the
error message in less than 1 minute.

Any ideia?

Thanks in advance!

Hello.

You should also set the RequestTimeout property to the same value as the CommandTimeout property.
https://www.stimulsoft.com/en/documenta ... imeout.htm

Thank you.