Stimulsoft Business Intelligence System | Forum

Dear Stimulsoft community,

I have an MRT/ report in which I would like to place multiple images in the same location but only display one image based on a variable condition, similar to a highlight condition for an image but this time for display purposes.

For example : If variable1 = 1 then the display should be image1 , Field is Value Data type numeric equal to 1
If variable2 = 2 then the display should be image2



Best regards

Hello,

Please send us a sample report with test data that reproduces the issue.

Thank you.

Hi Max,

The data doesn't matter we just need to set conditions on the images so I can display one image at a time.


You will find below two images that provide further explanation about the data and requirements, along with the MRT file.


Thanks

Hello,

Please check the attached report with example of condition.

Thank you.

Hi ,

In the example of condition, does the condition only affect the Highlight of the image or it also permit to hide an image if the condition is not respected ?
I tried using the "highlight condition" before, but it didn't impact the presence of the image. The images selected in the report are always visible, regardless of the condition applied to the input.

Best Regards

Hello,

To hide component the "Component Is Enabled" option should be unchecked.

Thank you.