Page 1 of 1
How to use ProcessingDuplicates
Posted: Mon Dec 23, 2024 3:21 am
by simon ren
Hello，
I would like to know how to use ProcessingDuplicates.
Even if a groupheaderband is used, it is not possible to group and merge them, but rather to merge them all,as shown in the figure
Re: How to use ProcessingDuplicates
Posted: Mon Dec 23, 2024 1:36 pm
by Lech Kulikowski
Hello,
Please check the sample report.
Thank you.
Re: How to use ProcessingDuplicates
Posted: Tue Dec 24, 2024 1:07 am
by simon ren
The effect I want is to merge based on the values in the first column. If the first column is different, the following columns will not be merged. If the first column is the same, they will be merged.
Just like in the figure, the values in the second column are all "1", but they are not merged completely. Instead, they are merged according to the first column
Re: How to use ProcessingDuplicates
Posted: Wed Dec 25, 2024 3:48 am
by simon ren
The problem has been resolved, thank you
Re: How to use ProcessingDuplicates
Posted: Fri Dec 27, 2024 10:13 am
by Lech Kulikowski
Hello,
You are welcome.