Set page not visible after rendering

Stimulsoft Reports.Net discussion
Post Reply
Scotty2
Posts: 8
Joined: Wed Jan 31, 2018 2:17 pm

Set page not visible after rendering

Post by Scotty2 » Tue May 21, 2019 8:31 am

I would like to use an option in an report, to Show only the first page for an overview.
At the first page there will be collected values and variables calculated at the following 5 pages.

When I set the following pages to page2.Enabled = false the page2 will not be rendered and no values provided. Same with other pages.
Is it possible to set a page not visible but rendering the page?

I also tried to use a contition for the not visible pages with "Component is Enabled" setting. But in this case the page will not be rendered either.

Thanks for your support
Lech Kulikowski
Posts: 1515
Joined: Tue Mar 20, 2018 5:34 am

Re: Set page not visible after rendering

Post by Lech Kulikowski » Tue May 21, 2019 8:56 am

Hello,

You can try to use DoublePass. In first - make all necessary calculations and in the end of pass hide all pages. In the second - show only first page.

Thank you.
Post Reply