Full Version still says demo

Arthur · Post by **Arthur** » Thu Jun 10, 2010 9:06 am

I have purchased the full version of the web designer. When I use the designer while developing on my local machine, I can see that it is loading the new version, but there is a moment while it is initially loading where it says "Demo" in the watermark, but when it finishes loading, the watermark is not there and it doesnt say anything when I save the report.

However, when I publish my project to a webserver and go to the designer, it is loads the old demo version. I get the save message telling me that it is the demo.

I have tried clearing my browser cache, and removing/re-adding all the entries in the GAC using the install utility that came with the full version of the designer multiple times with no success.

Do you have any other suggestions?

Post by **Vladimir** » Fri Jun 11, 2010 5:09 am

Hello, Arthur

Please let us know the product version you use. We will check it on our site.

Thank you.

agriffiths · Post by **agriffiths** » Sat May 07, 2011 11:42 pm

I too have just purchased report.web and even after uninstalling all trials (.net and .web) and reinstalling i still get demo on the desiger and also when I run my saved reports.

Post by **Andrew** » Sun May 08, 2011 12:38 am

Hello,

Thank you for the explanation.

But we still need to know which version do you use?
Did you download the version from your registered users area at http://www.stimulsoft.com/RegisteredUse ... ?login=yes ?

Thank you.

Post by **Andrew** » Sun May 08, 2011 12:42 am

... in addition have a you read the following topics?

http://stimulsoft.helpserve.com/index.p ... id=1&nav=0
http://stimulsoft.helpserve.com/index.p ... id=2&nav=0
http://stimulsoft.helpserve.com/index.p ... =344&nav=0
http://stimulsoft.helpserve.com/index.p ... =345&nav=0

Thank you.