Demo in Designer

Stephan1 · Post by **Stephan1** » Thu Sep 13, 2007 9:52 am

Hi,

after testing a while we decide to purchase the Reportdesigner.

I downloaded the "real" Version and install it.

Printing the Document no longer shows demo etc. which is fine.

The only Problem is, when i call " StiReport1.Design()" in my Application, the Designer still shows "DEMO".

Also when i started the Designer.exe which is also included in the purchased version it also still shows "DEMO".

Can someone pls help ? Do i have to compile the Designer.exe ? and why stireport.design still shows demo ?

Thx alot

Stephan

Brendan · Post by **Brendan** » Thu Sep 13, 2007 5:42 pm

you could try cleaning out the stimulsoft dlls from your application\bin directory and recompiling.

you could also try re registering the stimulsoft dlls in the GAC by removing the old ones and using the installer.exe from the stimulsoft installation folder to add the fullversion dlls back to the GAC.

Stephan1 · Post by **Stephan1** » Fri Sep 14, 2007 2:28 am

Thx Brendan,

this works fine.

Stephan