Dynamically add Sti components/elements to existing report

[mihiri1]

Hi,

I have a A3 Stimulsoft Report, Run the report and print to A3 paper, I get a nice report. but if I print it to A4 size paper, then some parts of the report gets cut off(only half of the report is visible on A4))
Then I tried setting Stretch to Print Area= True, this makes the report print fine to A3, but on A4 I see even though the columns are reduced in size, the font sizes still look the same. This results in some numbers and letters getting cut off from most of the columns.

What does the Stretch to Print Area really does?
How can I solve this issue?

Thanks

[HighAley]

Hello.

I have a A3 Stimulsoft Report, Run the report and print to A3 paper, I get a nice report. but if I print it to A4 size paper, then some parts of the report gets cut off(only half of the report is visible on A4))
Then I tried setting Stretch to Print Area= True, this makes the report print fine to A3, but on A4 I see even though the columns are reduced in size, the font sizes still look the same. This results in some numbers and letters getting cut off from most of the columns.

What does the Stretch to Print Area really does?
How can I solve this issue?

The Stretch to Print Area property change page margins to the print area.
Please, try to use the Page Size window on the Preview.
Could you write in the appropriate forum thread in future.

Thank you.

[mihiri1]

Hi,

Thanks

I could not find a way to add a new post to the forum.
Can you sow me how to.

Regards

[HighAley]

Hello.

Thanks

I could not find a way to add a new post to the forum.
Can you sow me how to.

You could do it by pressing New Topic button.

NewTopic.png (41.81 KiB) Viewed 2043 times

Thank you.