Hello,
Another problem.
When we define a variable and this variable is marked as "Request from user" it appear to the user when the runtime report is lunched.
Also below the window we have two buttons - Refresh and Close - this is OK, but after the user press Close there is no way to open the dialog again to change the selection.
Thank you
Regards
Tony
Variable apperiance
-
- Posts: 72
- Joined: Mon Jun 07, 2010 2:39 am
Variable apperiance
Hello,
We understand the problem. Most likely a special button on the viewer toolbar will be added. It will be used to show a closed panel with variables.
Thank you.
We understand the problem. Most likely a special button on the viewer toolbar will be added. It will be used to show a closed panel with variables.
Thank you.
-
- Posts: 251
- Joined: Fri Feb 04, 2011 11:46 am
- Location: San Diego, CA
Variable apperiance
After the user enters values for "Request from user" prompts ... what button are they supposed to do to have the report use these values?
If I press Refresh than the report "gets" the prompted values ... but the page is refreshed and the report uses the new values, but the prompts default to the original value.
If I press Close then the prompt fields are closed and the report never gets the data.
If I press Refresh than the report "gets" the prompted values ... but the page is refreshed and the report uses the new values, but the prompts default to the original value.
If I press Close then the prompt fields are closed and the report never gets the data.
Variable apperiance
Hello,
We have fixed this error, the update is available in the prerelease build on February, 15.
Thank you.
We have fixed this error, the update is available in the prerelease build on February, 15.
Thank you.