Hi Team,
we are using Stimulsoft version 2013.2. Recently, we encounter "Out of Memory" a lot.
it usually happens in two different cases:
- when we open and close couple of reports in design mode. it seems there is no good garbage disposal. what I mean is, if we open a report in design mode, it is fine. but when we close it and open the same report ( or another report) again and again, usually after 5-10 times, opening a report end up with "out of memory". Please note, we usually open one report in design at the time. it is anoying as we are designing custom reports for our clients in the system and in the middle of the design we get this error and we lose all our customization.
- when we add sort functionality in interaction mode. I designed a report with about 15 pages which has about 20 columns. if I dont add sort for the columns, ruining a report and changing the filter run time is working properly, but when I enable sort for the columns , the first time is ok , but the next time, or if user changing sorting by clicking columns, it end up in "Out of Memory" horrible page!
If I reduce the report size to 3-5 pages, it is working in both sort-able , non-sort-able mode properly.
Please note, I try differnt type of calculation ( compile/interpret ) and cache mode ( yes, no, auto). no difference. I have 16GB of memory so it shouldnt happen because no free memory.
just wondering:
- is there a way to increase the amount of memory used in the report?
- is there a way to clean up all occupied memory for old and closed reports?
I appreciate prompt response as it is rather critical.
Regards,
Ali
Out of Memory (Critical)
Re: Out of Memory (Critical)
Hello,
We made some improvements and optimizations in that direction in last versions.
Please check the latest build and let us know about the result.
Also you can reed the following articles on our blog:
http://blog.stimulsoft.com/articles/optimizing-reports
http://blog.stimulsoft.com/articles/opt ... rts-part-2
http://blog.stimulsoft.com/articles/opt ... rts-part-3
Thank you.
We made some improvements and optimizations in that direction in last versions.
Please check the latest build and let us know about the result.
Also you can reed the following articles on our blog:
http://blog.stimulsoft.com/articles/optimizing-reports
http://blog.stimulsoft.com/articles/opt ... rts-part-2
http://blog.stimulsoft.com/articles/opt ... rts-part-3
Thank you.