RFT export vs Viewer

JorisWils · Post by **JorisWils** » Mon Aug 08, 2011 8:58 am

Hi

I have a diffrence in export layouts again. Seems like every control gets some whitespace. Look at the table. The stimulsoft wpf viewer is the correct layout. Is there a solution for this?

Post by **HighAley** » Tue Aug 09, 2011 12:45 am

Hello.

There are several reasons why Word represents rtf file incorrectly. Please, send us report template and rendered report for reproduce the issue.

Thank you.

JorisWils · Post by **JorisWils** » Tue Aug 09, 2011 3:46 am

hi

I've sent an email to the support-mailbox.

Thx in advance.

Basically it comes to this: We want to generate documents using stimulsoft and export to pdf. Sometimes our users still have to edit the document so we make an export to rtf.
We open the rtf with word (2003 and 2010) ... but then the layout is incorrect.
Maybe you know of any tools that display the rtf correctly? preferably this would be a tool that is widely used like ms word is.

Post by **Ivan** » Fri Aug 12, 2011 6:53 am

Hello,

We made some improvements in that direction.
Please check the next prerelease build from 12-Aug-2011 when it will be available and let us know about the result.

Thank you.

JorisWils · Post by **JorisWils** » Tue Aug 16, 2011 4:46 am

Hi

I have tested "Stimulsoft Reports.Wpf 2011.08.14 " and I can see a lot of improvements have been made.

But now it seems that the page content of the RTF is smaller than the viewer. So that leaves me with some whitespaces on the bottom of every page in the RTF.
Enabling the "remove empty space at bottom of page"-option when exporting does not change this.

I also have a page border on each page. As the page content is now smaller, the table doesn't reach to the complete end of the page. So I get an "interupted" border.

Also in the report I've sent you on page 6 in the section "9. Fysische en chemische eigenschappen", the textboxes still have the whitespaces when I export to RTF. Could that be a textbox-version issue?

Once again, this is already a really big improvement! Congrats to the team!
I hope you can solve these last issues too.

Joris

By the way... this was Ticket ID: UEI-621294

Post by **Ivan** » Wed Aug 17, 2011 12:46 pm

Hello,

We are working on the problem. We will let you know when the solution is available.

Thank you.

Post by **Andrew** » Thu Aug 18, 2011 9:05 am

Hello,

Please send us an XSD scheme for your XML data.

Thank you.

JorisWils · Post by **JorisWils** » Thu Aug 18, 2011 9:35 am

Hi, I've sent it to the support-mailbox.

Post by **Andrew** » Thu Aug 18, 2011 10:45 pm

Hello,

Ok! Thank you.

Post by **Ivan** » Mon Aug 22, 2011 9:29 am

Hello,

We made some improvements in that direction.
Please check the next prerelease build when it will be available and let us know about the result.

Thank you.